IKEA

Stupid IKEA designs (do not buy...)

I’ve spent so much on GradEx that at OCAD I’ve literally only spent more on tuition.

Anyway, after talking with RT yesterday I went to Canadian Tire today to look for lighting systems. To my utter surprise, I found absolutely nothing. So I walked over to IKEA because I actually knew they have LED lighting systems.

So after spending more time than I should, I settled on the Omlopp countertop light because it seemed to look the best—even though it’s exceeding expensive for what I was going to do. The Omlopp is a complicated system and I actually managed to forget to get the power cord and had to later go back to IKEA to get it, losing two hours of precious setup time.

There’s also something about the shelving system I’ve chose that really bugged me: The Ekby Laiva is decent enough, but to install the Ekby Valter bracket with a power screwdriver is next to impossible. You can’t even use a normal manual screwdriver; you pretty much has to use an “offset screwdriver” because the spaces are so tight.

In any case let me get back to my point: after I tried installing the light to the second shelf a serious design problem with the Omlopp became very obvious—You can’t remove it. And I know this very well because I actually managed to install my second Omlopp backwards and after trying to pry it off (in order to fix it) for maybe half an hour I just gave up and concluded that prying it off is simply impossible.

Yes, you read that right: Once you’ve installed the Omlopp on anything you can’t take it back out. An Omlopp that has been “clicked” into place is as good as having been epoxied onto the shelf. The shelf and the light are now one; you can’t even repaint the shelf now.

It’s not that I haven’t seen stupid IKEA designs, but the Omlopp has to be the stupidest design I’ve ever seen, and it’s mighty expensive. If there’s anything I’m getting from this expensive exercise, it’s “Do not buy Omlopp.”

Syndicate content